What to do if my Beko WTL64051W does not drain water?
If your Beko Washer isn't draining water, the drain hose might be clogged or twisted. Try cleaning or flattening the hose. Additionally, the pump filter could be clogged, so try cleaning that as well.
Why is my Beko WTL64051W Washer leaking water from the bottom?
If you notice water leaking from the bottom of your Beko Washer, the water drain hose might be clogged or twisted. In this case, clean or flatten the hose. Also, the pump filter could be clogged, so cleaning the pump filter is advisable.
What to do if Beko Washer programme does not start after closing the door?
If the Beko Washer programme doesn't start after closing the door, make sure you've pressed the Start / Pause / Cancel button. Also, if you've loaded too much laundry, it may be difficult to close the loading door properly; reduce the amount of laundry and ensure the door is fully closed.
Why does laundry remain wet after the programme ends in my Beko Washer?
If your laundry remains wet after the programme ends in your Beko Washer, it could be because excessive foam occurred, activating the automatic foam absorption system due to too much detergent usage. Use the recommended amount of detergent.
Why does my Beko WTL64051W Washer directly discharge the water it takes in?
If your Beko Washer immediately discharges the water it takes in, the draining hose might not be at an adequate height. Connect the water draining hose as described in the operation manual.
Why is my Beko WTL64051W Washer vibrating and making noise?
If your Beko Washer is vibrating or making noise, several factors could be responsible. First, ensure the machine is standing balanced by adjusting the feet. Remove the transportation safety bolts, if you haven't already. Check the pump filter for any hard substances and clean it if necessary. The laundry quantity might be too little or too much; adjust the load accordingly. Finally, make sure the machine isn't leaning on any rigid item.
Why does washing take longer than specified in the manual on my Beko Washer?
Several factors can cause your Beko Washer to take longer than expected. Low water pressure can extend washing time as the machine waits to take in enough water. Low voltage and low input water temperature can also prolong the wash. The number of rinses or the amount of rinse water may have increased. Excessive foam from too much detergent can activate the automatic foam absorption system, also lengthening the cycle. In this case, use the recommended amount of detergent.
Why is there detergent residue in the detergent drawer of my Beko Washer?
If you're finding detergent residue in the drawer of your Beko Washer, the drawer may have been wet when you put the detergent in. Dry the detergent drawer before adding detergent. The detergent itself may have gotten damp, so keep detergents closed in a humidity-free environment and avoid excessive temperatures. Low water pressure, blocked holes in the detergent compartment or detergent mixed with the softener can also cause this problem. Check the holes and clean if they are clogged. Don't mix the softener with detergent and wash the dispenser with hot water.
Why does laundry turn gray after washing in my Beko Washer?
If your laundry turns gray after washing in your Beko Washer, it could be due to using an insufficient amount of detergent over a long period, washing at low temperatures for too long, or using too much detergent. Ensure you use the recommended amount of detergent appropriate for water hardness and the laundry. Select the proper temperature for the laundry to be washed.
Why do stains persist or laundry is not whitened after washing in my Beko Washer?
If stains persist or your laundry isn't whitened after washing in your Beko Washer, you might not be using enough detergent, or you might be loading too much laundry. Make sure to use the recommended amount of detergent and avoid overloading the machine. Also, you might have selected the wrong programme or temperature, or you might be using the wrong type of detergent. Select the proper programme and temperature, and use an original detergent appropriate for the machine. Avoid using too much detergent.
To Next Page
General
