Why do my clothes smell unpleasant after washing in my Beko WTL72051W Washer?
If your clothes smell unpleasant after washing in your Beko Washer, it's likely due to odors and bacteria forming on the drum from continuous washing at low temperatures or in short programmes. To prevent this, leave the detergent drawer and loading door ajar after each wash to avoid a humid environment that encourages bacteria growth.
Why is my Beko Washer leaking water from the bottom?
If you notice water leaking from the bottom of your Beko Washer, it could be due to a clogged or twisted water drain hose. Try cleaning or flattening the hose. Another possible cause is a clogged pump filter, so cleaning the pump filter may resolve the issue.
Why doesn't my Beko Washer go to the spinning step?
Your Beko Washer might not switch to the spinning step because of an unbalanced load; the automatic load detection system may be activated. Also, the machine won't spin if water isn't completely drained, so check the filter and draining hose. Excessive foam from too much detergent can also prevent spinning; use the recommended amount of detergent.
Why doesn't my Beko WTL72051W Washer rinse well?
If your Beko Washer isn't rinsing well, it could be due to: inappropriate detergent (amount, brand, or storage); use a suitable detergent and store it properly. Also, detergent in the wrong compartment can cause issues; ensure it's in the correct compartment. A clogged pump filter or a folded drain hose can also affect rinsing; check the filter and hose.
Why does my Beko Washer go into standby or not take in water?
If your Beko Washer enters standby mode or doesn't take in water, check if the tap is turned on and turn it on if necessary. Also, ensure the water inlet hose isn't bent; flatten it if it is. The water inlet filter might be clogged, so clean it. Make sure the loading door is closed properly. If the water connection is wrong or water is cut off, check the connection. If the water is cut off, press the Start/Pause key after the water has been supplied again to resume the operation.
Why did my Beko WTL72051W Washer stop shortly after the programme started?
If your Beko Washer stopped shortly after the programme started, it may have stopped temporarily due to low voltage. It will resume running when the voltage returns to normal.
Why is foam overflowing from the detergent drawer of my Beko WTL72051W Washer?
If foam is overflowing from the detergent drawer of your Beko Washer, it's likely because too much detergent is being used. To resolve this, mix 1 tablespoonful of softener with ½ liter of water and pour it into the main wash compartment of the detergent drawer. Be sure to use detergent suitable for the programmes and maximum loads indicated in the 'Programme and consumption table'. Reduce the amount of detergent when using additional chemicals like stain removers or bleach.
Why is the color of clothes faded after washing in Beko WTL72051W?
The color of clothes might fade after washing in your Beko Washer if you've loaded too much laundry; avoid overloading. Also, if the detergent is damp, keep detergents closed in a humidity-free environment and avoid high temperatures. Selecting too high a temperature can also cause fading; select the appropriate programme and temperature for the laundry type and soiling degree.
Why is my laundry stiff after washing in my Beko Washer?
Laundry can become stiff after washing in your Beko Washer if you're using too little detergent for the water hardness; use an appropriate amount. Also, ensure you're putting detergent in the correct compartment, not mixing it with softener. If detergent is put in the prewash compartment although prewash cycle is not selected, machine can take this detergent during rinsing or softener step. Put the detergent in the correct compartment. Don't mix softener with detergent; clean the dispenser with hot water.
Why is there too much foam in my Beko Washer?
Excessive foam in your Beko Washer can occur due to several reasons: * Using improper detergents for the washing machine; use appropriate detergents. * Using too much detergent; use only a sufficient amount. * Improper detergent storage; store detergent in a closed, dry location, not in excessively hot places. * Some meshed laundry like tulle may foam excessively; use less detergent for these items. * Detergent in the wrong compartment; put detergent in the correct compartment. * Softener being taken early; there may be a problem in the valves or dispenser; contact an Authorized Service Agent.
Safety guidelines to prevent injuries and property damage from appliance use and maintenance.
Precautions for safe use by children, including supervision and secure storage of detergents.
Essential electrical safety measures, including grounding and handling of the power cord.
Guidelines for selecting a suitable and stable location for the washing machine installation.
Step-by-step instructions for safely removing transportation safety bolts before operation.
Detailed instructions for correctly connecting the washing machine to the water inlet.
Procedure for properly attaching the drain hose to ensure efficient water discharge.
Guidance on safely connecting the washing machine to the electrical power source.
Detailed instructions on selecting and using detergents and softeners in the correct compartments.
Identification and explanation of the washing machine's control panel buttons and indicators.
Step-by-step guide for cleaning the detergent drawer and its siphon component.
Instructions for cleaning the drum and door, including regular maintenance reminders.
Procedure for cleaning the filters located at the water inlet valves and hoses to prevent blockages.
Instructions for draining residual water and cleaning the pump filter for optimal performance.
Solutions for issues where the programme fails to initiate after the door is closed.
Troubleshooting steps for problems encountered when starting or selecting wash programmes.
Explanations for the presence of water in the machine when it should not be there.
Steps to resolve issues where the machine enters standby mode or fails to draw water.
Solutions for problems related to the machine's inability to drain water effectively.
Causes and solutions for excessive vibration or unusual noises emanating from the machine.
Troubleshooting guide for identifying and resolving water leaks from the appliance's base.
Reasons and remedies for the machine stopping unexpectedly during a wash cycle.
General| Manual | Yes |
|---|---|
| Package depth | 515 mm |
| Package width | 650 mm |
| Package height | 880 mm |
| Package weight | 57000 g |
| Drum capacity | 7 kg |
| Cycle time (max) | 207 min |
| AquaStop function | - |
| Delay start (max) | 9 h |
| Residual moisture | 52 % |
| Spin-drying class | B |
| Maximum spin speed | 1200 RPM |
| Noise level (spin) | 74 dB |
| Noise level (wash) | 57 dB |
| Adjustable temperature | No |
| Number of washing programs | 15 |
| Maximum water flow pressure | 1000 kPa |
| Minimum water flow pressure | 100 kPa |
| Cycle time (quick washing program) | 28 min |
| Current | 10 A |
| Connected load | 2200 W |
| Power plug type | Type G |
| AC input voltage | 230 V |
| AC input frequency | 50 Hz |
| Energy efficiency scale | A to G |
| Power consumption (off) | 0.5 W |
| Power consumption (left-on) | 1 W |
| Water consumption per cycle | 45 L |
| Energy consumption washing per cycle | 0.685 kWh |
| Energy efficiency index (EU 2017/1369) | 1.04 |
| Feet adjustment | 15 mm |
| Door hinge | Left |
| Motor type | Brushless |
| Water fill | Cold |
| Control type | Rotary |
| Loading type | Front-load |
| Drum material | Stainless steel |
| Product color | White |
| Inlet hose length | 1.3 m |
| Door opening angle | 170 ° |
| Appliance placement | Freestanding |
| Hose diameter | 20 mm |
| Washing class | A |
| Required tools | Standard tool box |
| Paper packaging weight | 10 g |
| Plastic packaging weight | 140 g |
| Harmonized System (HS) code | 84501190 |
| Expanded Polystyrene (EPS) packaging weight | 813 g |
Weight and Dimensions| Depth | 490 mm |
|---|---|
| Width | 600 mm |
| Height | 845 mm |
| Weight | 56000 g |
| Door diameter | 340 mm |
To Next Page
