What to do if my Beko WTL72051 Washer does not drain water?
If your Beko Washer isn't draining water, the water drain hose might be clogged or twisted, so clean or flatten the hose. Alternatively, the pump filter could be clogged; in this case, clean the pump filter.
Why is my Beko WTL72051 Washer leaking water from the bottom?
If you notice water leaking from the bottom of your Beko Washer, it could be due to a clogged or twisted water drain hose. Try cleaning or flattening the hose. Another possible cause is a clogged pump filter, so cleaning the pump filter may resolve the issue.
Why doesn't my Beko WTL72051 Washer go to the spinning step?
Your Beko Washer might not switch to the spinning step because of an unbalanced load; the automatic load detection system may be activated. Also, the machine won't spin if water isn't completely drained, so check the filter and draining hose. Excessive foam from too much detergent can also prevent spinning; use the recommended amount of detergent.
Why doesn't my Beko WTL72051 rinse well?
If your Beko Washer isn't rinsing well, it could be due to: inappropriate detergent (amount, brand, or storage); use a suitable detergent and store it properly. Also, detergent in the wrong compartment can cause issues; ensure it's in the correct compartment. A clogged pump filter or a folded drain hose can also affect rinsing; check the filter and hose.
Why does my Beko WTL72051 go into standby or not take in water?
If your Beko Washer enters standby mode or doesn't take in water, check if the tap is turned on and turn it on if necessary. Also, ensure the water inlet hose isn't bent; flatten it if it is. The water inlet filter might be clogged, so clean it. Make sure the loading door is closed properly. If the water connection is wrong or water is cut off, check the connection. If the water is cut off, press the Start/Pause key after the water has been supplied again to resume the operation.
Why is my laundry still wet after the Beko WTL72051 Washer programme ends?
If laundry remains wet after the programme ends on your Beko Washer, it could be due to excessive foam caused by using too much detergent. Use the recommended amount of detergent to prevent this.
Why is my Beko WTL72051 Washer vibrating and making noise?
Your Beko Washer may be vibrating or making noise due to several reasons: * The machine might be unbalanced; adjust the feet to level it. * A hard substance might be in the pump filter; clean the pump filter. * Transportation safety bolts may not be removed; remove them. * The laundry quantity might be too little; add more laundry. * The machine might be overloaded; take some laundry out or redistribute it. * The machine might be leaning on something; ensure it's not leaning on any rigid item.
How to start a Beko Washer programme after closing the door?
If the programme on your Beko Washer doesn't start after closing the door, make sure you press the Start / Pause / Cancel button. Also, if you have loaded too much laundry, it may be difficult to close the loading door properly. Reduce the amount of laundry and ensure the door is closed correctly.
Why does washing take longer than expected on my Beko WTL72051 Washer?
Washing cycles on your Beko Washer might take longer than expected due to several reasons: * Low water pressure: the machine waits for adequate water intake. * Low voltage: washing time is prolonged to avoid poor results. * Low input water temperature: heating the water takes longer. * Increased rinses: the machine increases rinse water or adds an extra rinse if needed. * Excessive foam: the automatic foam absorption system may activate if too much detergent is used; use the recommended amount.
Why is there too much foam in my Beko Washer?
Excessive foam in your Beko Washer can occur due to several reasons: * Using improper detergents for the washing machine; use appropriate detergents. * Using too much detergent; use only a sufficient amount. * Improper detergent storage; store detergent in a closed, dry location, not in excessively hot places. * Some meshed laundry like tulle may foam excessively; use less detergent for these items. * Detergent in the wrong compartment; put detergent in the correct compartment. * Softener being taken early; there may be a problem in the valves or dispenser; contact an Authorized Service Agent.
General| Type | Front Load |
|---|---|
| Capacity | 7 kg |
| Spin Speed | 1200 rpm |
| Energy Rating | A+++ |
| Energy Efficiency Class | A+++ |
| Noise Level (Spinning) | 75 dB |
| Number of Programs | 15 |
| Delay Start | Yes |
| Child Lock | Yes |
| Water Consumption | 45 L |
Explains the meaning of various symbols used throughout the user manual for clear understanding.
Guidelines to prevent injuries and material damage from product use.
Precautions for safe use and supervision of children around the appliance.
Essential safety measures regarding electrical connections and usage.
Warnings about hot surfaces and keeping children away from them.
Information on waste disposal and packaging materials.
Specifies the intended domestic use and limitations for the washing machine.
Provides a general overview of the washing machine's parts and features.
Lists all items included in the product packaging.
Details the technical data and specifications of the washing machine.
Step-by-step instructions and guidelines for installing the washing machine.
Covers sorting laundry, preparing it, and tips for efficient washing.
Explains control panel, programme selection, and operation modes.
Instructions for regular cleaning of various parts of the washing machine.
Addresses issues like programme not starting, no water, or excessive noise with solutions.
Solutions for problems like slow washing, poor rinsing, or faded clothes.
Outlines what is covered, not covered, and important notes for the manufacturer's guarantee.
Specific terms for the 10-year guarantee on ProSmart Inverter Motors.
Information on how to get help and contact the service centre.
Guidance on registering the product for warranty purposes.
To Next Page
