What to do if my Beko WTV7611BBW does not drain water?
If your Beko Washer isn't draining water, the water drain hose might be clogged or twisted; try cleaning or flattening it. Alternatively, the pump filter could be clogged; in that case, clean the pump filter.
How to open the loading door of my Beko WTV7611BBW?
If the loading door of your Beko Washer cannot be opened, it might be due to several reasons. The door lock may be activated because of the water level; drain the water by running the Pump or Spin programme. The machine could be heating water or in the spinning cycle; wait until the programme completes. The child lock might be engaged; wait a couple of minutes for deactivation. The door may be stuck due to pressure; try pushing and pulling the door to release it. Also, low water pressure, low voltage, or low input water temperature can prolong the cycle. Finally, the machine might have increased the amount of rinse water.
Why is my Beko WTV7611BBW Washer leaking water from the bottom?
If you notice water leaking from the bottom of your Beko Washer, inspect the water drain hose for clogs or twists and clean or flatten it. Also, check the pump filter for any blockages and clean it if necessary.
Why doesn't my Beko WTV7611BBW switch to the spinning step?
If your Beko Washer does not switch to the spinning step, there might be an unbalanced load in the machine, triggering the automatic unbalanced load detection system. Ensure that the water is drained completely by checking the filter and the draining hose. Excessive foam due to too much detergent usage may also activate the automatic foam absorption system; use the recommended amount of detergent.
Why does too much foam form in my Beko Washer?
If too much foam is forming in your Beko Washer, make sure you're using detergents appropriate for washing machines and only use a sufficient amount. Store detergent in a closed, dry location, away from excessive heat. Some meshed laundry items may create excessive foam, so use less detergent for them. Also, ensure the detergent is placed in the correct compartment.
What to do if the Beko WTV7611BBW Washer programme does not start?
If the programme on your Beko Washer doesn't start after closing the door, ensure that you press the Start / Pause / Cancel button. If the loading door is difficult to close due to excessive loading, reduce the amount of laundry and ensure the door is closed properly.
Why doesn't the programme time countdown on my Beko WTV7611BBW?
If the programme time on your Beko Washer isn't counting down, the timer may stop during water intake until the machine takes in enough water. The timer may also stop during the heating step until the selected temperature is reached. Additionally, the timer can stop during the spinning step if the automatic unbalanced load detection system is activated.
Why does my laundry turn gray after washing in my Beko WTV7611BBW Washer?
If your laundry turns gray after washing in your Beko Washer, it could be due to insufficient detergent used over a long period, so use the recommended amount. Washing at low temperatures for a long time can also cause this, so select the proper temperature. Insufficient detergent with hard water can also cause graying; use the recommended amount. Using too much detergent can also contribute.
Why is foam overflowing from the detergent drawer of my Beko WTV7611BBW?
If foam is overflowing from the detergent drawer of your Beko Washer, it's likely due to using too much detergent. Mix 1 tablespoonful of softener with ½ liter of water and pour it into the main wash compartment. Ensure you use detergent suitable for the programmes and maximum loads indicated in the “Programme and consumption table”, and reduce the amount of detergent when using additional chemicals like stain removers or bleach.
To Next Page
General
