IMPORTANT! Fill the tanks at the end
of each operating day to prevent con-
densation in the fuel tank.
Breakaway and tractor moving
NOTE: Refer to the travel speed chart
in section «В» of this manual for de-
sired speed range selection (р. В6).
1. Tractors with 16F+8R gear box
To drive a tractor, please, do as follows:
• Reduce engine speed.
• Depress the clutch pedal.
• Select a desired gear range of the gear
box:
- Move the lever (1) to an extreme
right-hand (spring-loaded) position
and pull it to yourself or push the
lever away to select a desired
range: I (low) or II (high) ones ac-
cordingly;
- Return the lever to neutral position
(«N») and then turn the lever to the
left to select a desired gear range in
accordance with shift pattern I.
• Select a desired speed with the lever
(2) as per shift pattern II.
• Turn off a parking brake, release a
clutch pedal smoothly and simulta-
neously speed up the engine – a trac-
tor starts moving.
WARNING! Always depress a clutch ped-
al before selecting a required gear range
or gear in the gear box.
IMPORTANT!
Shift gear ranges (by gear clutch) only
when a tractor is stopped.
To shift a gear smoothly without sharp
pushes, displace the gear shift lever (2)
in accordance with pattern II (see the
picture above) and hold it in a pressed
position till the gear is fully shifted.
While operating a tractor, do not keep
your foot on a clutch pedal. It will result
in clutch slipping, its overheating and
breaking.
To Next Page