Reversible station controls.
The additional reverse controls are
located at the rear side of the cab
as shown in the figure below:
1 - the clutch is disengaged when
pressing the pedal. Clutch en-
gagement takes place by pedal
release.
2 –steering wheel of tractor turning
(it is taken from the steering
column of forward motion (9)).
3 –brakes pedal. Both tractor
brakes and pneumatic drive of
trailer brakes are engaged by
depressing the pedal.
4 –foot throttle. Fuel feeding is in-
creased by pressing the foot
throttle.
5 – horn button.
6 –fuel delivery control lever. Ex-
treme rearward position (on re-
verse) corresponds to full fuel
delivery, extreme forward posi-
tion corresponds to engine
stopping.
7 –gearbox ranges selecting lever
(see pattern I).
8 –transmission speed control lever
(see pattern II).
9 –steering column of forward mo-
tion.
To adjust the tractor for reverse
operation, proceed as follows:
• lock the standard brake pedals;
• transfer the steering wheel to the
additional steering column. For that
purpose turn off the handwheel of
the steering wheel fixation, transfer
the steering wheel and fix it at the
required height;
• turn the revolving seat for reverse
operations;
• set the HPS switch cock to the
“reverse” position.
To Next Page