BelFone BF-TD511 - Dual Capacity Direct Mode; Radio Priority-Based Interrupt

33
mute.
Note: This feature is effective on digital channel.
Dual Capacity Direct Mode
If enable TDMA direct mode, the members in the same group call must use the
same slot, one frequency supports calls in two slots synchronously in order to avoid
interfering communications in the other slot.
Via programmable software to set it: Channels folder→Zone→a digital channel or
A/D Channel→TDMA Bypass Mode→Slot Align→Slot→Pseudo Trunk TX Slot
Note: This function is available only in digital operation.
Radio Priority-Based Interrupt
The call priority feature allows you to interrupt the on-going call on current forcibly,
a preemptive call can interrupt other on-going calls with lower priority to release the
channel for itself. There are 5 voice priorities available, level 0 is lower, level 3 is higher,
and emergency call is the highest. To transmit the Priority Interrupt command also can
press the programmed [Priority Interrupt] key, in order to make the channel free for new
call or message transmission.
Via programmable software to set it: Channels folder→Zone→a digital channel or
A/D Channel→Priority Interrupt→Voice Priority
Note: This function is available only in digital operation.