37
on the current channel, CTCSS/CDCSS match is required for the radio to
receive an incoming signal. You can select a CTCSS/CDCSS from CTCSS
standard frequency table or CDCSS standard code table or input non standard
values manually via the programming software.
●Decode: Only when receiver receives a call containing matching the decode,
you can hear the call;
●Encode: Signal that you transmit will only be heard by parties whose
CTCSS/CDCSS signaling matches your transceiver.
Note：On analog channel approves of non-standard code, you can manually input
non-standard code as you need, on compatible channel, only can select a certain
CTCSS/CDCSS from list.
Analog Signaling
2-Tone Signaling
2-Tone Contact
While users set 2-Tone signaling type for the current channel, the 2-tone
contact supports a maximum of 32 2-Tone call list, on the menu of 2-Tone
contact; you can select one of the contacts to send.
Send 2-Tone Signaling
On analog channel, press the programmed “one touch call” key to send 2-tone
signaling, the radio displays:” 2-Tone Call Sending”.
To Next Page
Loading...