VideoLink 3
Powerline Internet Adapter
Installing and Setting Up the Adapter
1. Plug the Adapters into power outlets;
one in the room with your other network
equipment, and the other in a room
where you would like to have network
access. When the Adapters recognize one
another, their Powerline Link lights
will glow.
Note: Do not plug the Adapter into a
power strip; doing so may degrade
network performance.
2. Connect one of the Adapters to your
existing modem or router with a network
cable. Use a second network cable to
connect the other Adapter to an Internet
TV, Blu-ray
®
player, computer, or other
network device such as a wireless access
point, set-top box, or gaming console.
Belkin VideoLink 3 Powerline Internet Adapters allow you to extend your network over your home’s
existing wiring.
Quick Installation Guide
Knowing Your Belkin
VideoLink 3 Powerline
Internet Adapter
Power LED (Right)
Solid Green – Power on
Off – Power off
Blinking Green – During
encryption setup
Solid Green – Encryption
setup successful
Double Flash – Fail in encryption
Powerline Link LED (Middle)
Blinking – Powerline data
transmitting or receiving
Color Green – Link rate excellent:
greater than 80Mbps
Color Amber – Link rate low:
less than 80Mbps
Off – No activity
Ethernet Link LED (Left)
Solid Green – 10/100Mbps port linked
Off – No Ethernet link
To Next Page
Need help?
General
