Problem:
The Easy Install Wizard cannot connect my Router to the Internet.
Solution:
If the Easy Install Wizard is not able to connect the Router to the
Internet, please check the following items:
1. Use the troubleshooting suggestions within the Easy Install Wizard.
If the troubleshooting screen does not open automatically, click on
the “Troubleshoot” button in the lower, right-hand corner of the Easy
Install Wizard window.
2. If your ISP requires a user name and password, make sure that you
have typed in your user name and password correctly. Some user
names require that the ISP’s domain be at the end of the name.
Example: “myname@myisp.com”. The “@myisp.com” part of the user
name may need to be typed as well as your
user name.
If you continue to have no Internet connection, reference the section
titled “Manually Configuring Network Settings” (page 84 of this User
Manual) for an alternate setup method.
Problem:
• The Easy Install Wizard completed installation, but my web browser
doesn’t work.
• I am unable to connect to the Internet. The Router’s “WAN” light is
off and the “Connected” light is blinking.
Solution:
If you cannot connect to the Internet, the “WAN” light is off, and the
“Connected” light is blinking, the problem may be that your modem and
Router are not connected properly.
1. Make sure the network cable between the modem and the Router
is connected. We strongly recommend using the cable that was
supplied with your cable or DSL modem for this purpose. The cable
should be connected at one end to the Router’s “Internet/WAN” port,
and at the other end to the network port on your modem.
2. Unplug the cable or DSL modem from its power source for three
minutes. After three minutes, plug the modem back into its power
source. This may force the modem to properly recognize the Router.
To Next Page
Loading...
