Bell'O SP-224 User Manual

© 2002 Bell'O International, LLC
Bell’O International Corp. will not be responsible for failure to assemble as directed or for the improper assembly, use or handling of this stand.
Bell’O International Corp.
711 Ginesi Drive
M
organville, NJ 07751-1235
Customer Service: (888) 235-7646
E
-mail: support@bello.com
Web: www.bello.com
SP-224
ASSEMBLY INSTRUCTIONS
Italian Designed • Made in China
8
x
8 x
8
x
4
x
4 x
1 x
4 x
M-1
A. Place the two curved base sections (2 & 3)
on floor against stand center column (1) as
shown in drawing, making certain that holes
are aligned.
B. Insert and fasten the two long screws (4)
into the sides of the stand as shown.
C. Insert and fasten the two short screws (5)
and washers (10) into the rear of the stand
as shown.
D. Insert the spikes (6) or plastic floor levelers
(7), which are supplied in the parts bag, into
the holes located under the stand base.
E. If the floor leveler spikes (6) are used, also
mount the four washers (9), which are
supplied in parts bag, to fasten and lock
the spikes in position.
NOTE: TO AVOID SPEAKER DAMAGE OR
POSSIBLE INJURY, USE THE SUPPLIED
HOOK & LOOP ADHESIVE STRIPS TO
SECURE YOUR SPEAKERS TO THE
SPEAKER STAND.
IMPORTANT: REMOVE THE SPEAKERS
FROM THE STAND PRIOR TO MOVING THE
ASSEMBLED UNIT. WHEN IN USE THESE
STANDS MUST BE PLACED ON A FLAT AND
LEVEL SURFACE.
Note: One person can assemble this unit.
9
6
9
10
5
6
2
4
4
8
3
1
Allen Wrench
Plastic Levelers
T
hreaded Washer
Washer
L
eveler Spikes
1
2mm Short Screw
1
8mm Long Screw
8
7
9
10
6
5
4

Bell'O SP-224 Specifications

General

Brand	Bell'O
Model	SP-224
Category	Indoor Furnishing
Language	English

Summary

SP-224 Assembly Instructions

List of Supplied Hardware

Details all necessary parts and quantities for assembling the SP-224 unit.

Step A: Base Section Placement

Position the two curved base sections against the stand center column, aligning holes.

Step B: Fasten Long Screws

Insert and secure the two long screws into the sides of the stand as illustrated.

Step C: Fasten Short Screws and Washers

Insert and fasten the two short screws with washers into the rear of the stand.

Step D: Insert Floor Levelers or Spikes

Insert the provided spikes or plastic levelers into the holes under the stand base.

Step E: Secure Leveler Spikes

If using spikes, attach the four washers to fasten and lock them in position.

Important Safety & Usage Notes

Information on securing speakers and essential placement requirements for stability.