Bell 300 Series User Manual

SECTIONC38.549
4.03 BATTE_RIES • Voltage should exceed 4 volts after meter is
connected for approximately 1 minute.
• Test by connecting leads from meter across
• After checking contacts and batteries, if
terminals BK and 4 or BK and 1 if the
set still fails to function, replace amplifier
right-hand plunger has to be pulled up to
and capacitor.
connect amplifier in circuit.
• If set still fails to function, replace set.
Page6
6 Pages

Bell 300 Series Specifications

General

Dial	Rotary
Era	Mid-20th Century
Caller ID	No
Call Waiting	No
Redial	No
Volume Control	No
Phonebook	No
Display	No
Type	Desk phone
Design	Classic
Material	Plastic
Power Source	Telephone line