Bell SKIPPER Series - Steps 25-28: Final Assembly and Checks

Grab the straps and pull on them to conrm that the
harness is properly anchored to the seat in both the
upper locations as well as the center lower location.
Push the grab bar into the holes in the seat. The grab
bar can be removed by pinching the tabs together
and pushing upward.
Peel the backing off the adhesive tape and adhere
the reector to the untextured area of the back of the
seat. Press rmly in position.
Double check to make sure that all of the fasteners
are securely tightened.
This completes the assembly and installation of the
Child Carrier.
STEP 25
STEP 26
STEP 27
STEP 28
CONGRATULATIONS!