1. Prepare the base, 6 screws, and
two flywheels, and turn the base
upside-down.
2. Insert the flywheels into the end
hole on the base (keeping the hole
of the black insert part facing
upwards). Note the unsecured
end panel.
3. Lift the end panel up.
4. Place screws in the holes on
both sides of the black shaft
and tighten with a screwdriver.
5. Lower the end cover, place
one screw and tighten it with a
screwdriver, and secure the
end cover. Repeat this process
(from (b)) to attach the flywheel
on the other side.
6. Insert the four universal
wheels into the holes on the
base as indicated.
7. Placement of the wheels.
8. Insert the 2 step brakes into the
rectangular slots at the front of the
base as indicated.
To Next Page