for personal safety:
DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS APPLIANCE.
DO NOT, UNDER ANY CI RCUMSTANCES, CUT OR REMOVE THE
FROM THE POWER CORD.
EAR THING
CONNECTION
Improper connection of the equipment earthing conductor can result in the risk of an
electric shock.
Check with a qualified electrician or service representative if you are in doubt whether the
appliance is properly earthed.
Do not modify the plug provided with the appliance. If the plug does not fit properly to the
outlet, please have a qualified electrician to install a proper outlet.
Ins ert t he dr ain hose into a d ra in pi pe with a m inim um d i amet er of 4 cm, o r le t it r un in to th e si nk, m akin g sure t o
avoid b endin go r cri mping. U se t he s pecial plas tic sup por t that com es w ith the a ppl iance. Th e top of the h ose
must be at a hei ght b etween 40 a nd 1 00cm .Th e fre e end of t he hose must not be immersed in w at er.
A hose that a ttaches t o a s ink sp ray c an b urst i f i t i s inst alled on th e s ame wat e r li ne as t h e dis hwasher. If yo ur sin k
has on e, it is re commen ded t hat the h ose be d isco nne ct ed an d the hol e plu gge d.
Pull The safety supply hoses completely out from storage compartment lo cated at rear of dishwasher.
Turn water fully on before starting the dishwasher.
1
Tighter the screws of the safety supply hose to the faucet with thread 3/4in ch.
The sa fety supp ly hose cons ists of th e double wa lls. The hose's sy stem gu aran tee s i ts intervent ion by b lock ing t he
flow o f wa te r in case of t he s up pl yhose breaki ng and when t he ai r spa ce b etween t he s upply ho se itself and the outer
corr ug ated hose is fu l l of wa ter.
Turn off the water.
Release the water pressure by depressing the pressure release button. This relieves water pressure and protects you, and the
room, from severe splashing.
Unscrew the safety supply hose from the faucet.
3
2
1
2
3
The applian ce m us t be connected t o the w ater m ains usi ng n ew hos e-sets.
The old hose -s ets should not be reused.
Water pressure must bebetween 0,04 MPa and 1MPa. If the pressure is belowthe
m inim um consult o ur S ervi ce Department fo r adv ice .
Conne ct the cold water supply hose t o a threaded 3/4(inch ) conn ector and make su re that it is fastened tigh tly in place.
If the wat er pipes are new or have no t been use d f or an ext ended pe riod of t ime, let the wat er run t o ma ke sur e t hat the
wate r is clear a nd free of impur ities. If t his preca ution is no t ta ken, ther e is a risk that the wat er inl et ca n g et bloc ked
and damage the ap plian ce.
To Next Page
Loading...
