The following things should be checked before starting the dishwasher.
The content of this manual is very helpful to the users.
After installation, please make sure to keep this manual.
1
The dishwasher is level and fixed properly
2
T he i nlet va lv e i s o pen
3
There is a leakage at the connections of the conducts
4
The wires are tightly connected
5
The power is switched on
6
T he inl et and dr ain hoses a re kno tte d
7
All packing materials and printings should be taken out from the dishwasher
Syphon Connection
Extension Hose
If you need a drainhose extension, make sure to use a similar drain hose.
It must b e no lon ger t han 4 metres ; otherw ise the c leaning eff ect of the dishw as her coul d be redu ced.
Wa t e r O u t l e t
Connect the wa te r d rain h ose. Th e dr ain h ose mu st be corr ect ly fit ted t o av oid wate r lea ks.
Ensur e that the w ater dra in h ose is no t kin ked or s quashed .
The waste connection must be at a he ight of between40 cm (minimum) and 100 cm (maximum)
f ro m t he b ott o m o f t he di sh. The w a t er dr ain hose sh oul d be fix e d by a h ose clip. The f ree end of
the hose mu st not be imm erse d in wat er.
I f the si nk is 1 00 0 h igh er from t he fl oor, the exc ess w a te r in h o ses ca nnot be dra ined dir ec tl y
into the sink. It will be necessary todrain excess water from hoses into abowl o rsuitable
containe r that is held outside and lower th an t he s ink.
How to Drain Excess Water From Hoses
FRONT VIEW
Inlet pipe connector Drain pipe connector
POWER OUTLET
SINK
DISHWASHER
Min 100mm
To Next Page
Loading...
