EasyManua.ls Logo

Bellini BTICM150 - Storage; Care and Cleaning; Troubleshooting; Specification

Bellini BTICM150
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
Care and Cleaning
Switch off and unplug the Ice Cream Maker from
the power outlet.
Disassemble and wash the freezer canister in
warm water with mild detergent.
Rinse well and dry thoroughly.
Note: Do not place any part of the Ice
Cream Maker in the dishwasher.
Wipe the exterior of the motor unit with a soft
damp sponge or cloth.
Do not clean with abrasive cleansers or
implements. Dry all parts thoroughly.
Note: Sharp utensils, scouring pads or
abrasive detergents may harm your
appliance.
Troubleshooting
Ice Cream texture is too soft/liquid
The canister must be kept and frozen in the
freezer properly. The freezer’s temperature
must be lower than -17ºC at all time. If for some
reason the freezer cannot go lower than -17ºC,
the ingredients have to be the coldest possible.
To do this, put the ingredients in the freezer until
the ingredients start to crystallize (approximately
one hour), then pour the ingredients into the ice
cream maker.
The paddle isn’t turning
Only the canister turns. The paddle should remain
stationary.
Specication
Voltage...........220-240V ~ 50Hz
Wattage..................50W
Storage
The ice cream mixture can be frozen further by
placing the freezer canister into the freezer for no
more than thirty minutes.
To store your ice cream for long periods of time,
place it in an air tight container in the freezer.
Do not put freezer canister in freezer if
the canister is wet and not protected by
a plastic bag. Do not store lid, paddle, or
motor base in freezer.