ASSEMBLY:
1. Installation of the outer tube and the base: insert the tube
into the hole one the base, then fasten the screws on the base.
2. Installation of the fan: set the fan in the adjustable pole and
fasten the fan.
3. Installation of the rear grille: put the rear grille on the motor
housing and fasten it with the mounting nut.
4. Installation of the Blade: Push along the motor shaft and
fasten rmly the blade with blade cap.
5. Installation of the front grille: Hang the front grille to rear
grille with the position xer provided at the rim of grill and
then x together with clips provided.
USE
1. Ensure that the fan is switched o.
2. Place the fan on a dry and level surface and plug the pow-
er cord into a grounded 220–240 V/50 Hz alternating current
socket, which must conform to the requirements described in
the safety instructions.
3. Adjust the tilting angle: set the fan to the desired angle.
4. Air ow settings:
0 = OFF
1 = slow
2 = medium
3 = fast
5. Oscillation: To enable or disable the oscillation feature, press
down or pull up the oscillation knob on top of the fan casing.
CLEANING AND STORAGE
1. Ensure that the fan is switched o.
2.Unplug the power cable from the power source.
3.Loosen the guard ring and remove the front guard.
4.Carefully wipe the blade and guards with a damp cloth.
5. DO NOT immerse the fan in water or let water into the mo-
tor casing.
6.DO NOT use petrol, paint thinner or other chemicals when
cleaning the fan.
7.When storing the fan, disassemble it and carefully clean it
by following the instructions. Always store the fan in its origi-
nal packaging. The fan must not necessarily be disassembled.
It can also be covered to protect it from dust. Store the fan in a
cool and dry place.
To Next Page
Loading...