Procedure to Configure the Scanner
Bematech barcode readers are plug&play and have Market standards
features configured as default values.
Factory default values are highlighted with a square box around its
description.
This guide will help you to adapt the scanner do better fit your
preferences, such as interface type, beep volume, among others usual
configuration.
To properly configure your scanner, please follow the steps bellow:
To have access of all programmable features see the user manual on
our website: www.bematech.com
Important!
Every program must start by Reading the code
“Start of Configuration”, located at the top of the
page and finish by reading the code “End of
configuration”, located at the bottom of the page
Be careful to don’t read all codes with the same
function, read only the feature that you wish to
enable/disable.
To Next Page
Loading...
Need help?
General
