26 27
OPERATION (CONT.) CLEANING
Set the Unit
• Unplug the unit and then plug it back in.
• Push the power bidet button on the side of the unit to turn the unit off.
• Push the button again and this time hold it down.
(It should turn on when you do this).
• While holding that button down, push the stop button
on the remote for 2 seconds.
NOTE
• If ID’s of the remote control and the main unit are different,
the main unit will not work.
• Make sure the remote control and the main unit are set with the same ID.
• ID will remain even if the power is unplugged or the batteries
of the remote control are replaced.
CAUTION: Do not forcefully push, pull, or bend the nozzles.
It may result in failure. Make sure to use the “Stop” button
on the remote control.
NOZZLE CLEANING
Manual Cleaning
1. Make sure the occupied
sensor is not activated.
(Do not sit on the seat
or place hands on the
seat sensor.)
2. Press Front button
for 2 seconds to extract
the bidet nozzle.
3. Use a toothbrush or soft cloth
to clean the nozzle.
4. Press the Stop button to
retract the nozzle.
Auto Cleaning
1. Press Rear button for 2 seconds to start auto cleaning.
The nozzle will be cleaned for 30 seconds and returned automatically.
2. Press the Stop button while cleaning to retract the nozzle.
3. Do not force to push or pull the nozzles while cleaning.
To Next Page
Loading...