BEMIS Flow Grove - CONTINUED INSTALLATION GUIDE; Connecting Hot and Cold Water Lines; Battery Box Mounting and Installation

12 13
GETTING STARTED
3. Connect Supply Lines
Connect the hot & cold supply lines
onto the matching water
valves and secure the connection
with an adjustable wrench.
4. Install Battery Box
1. Secure the battery bracket by using 3M adhesive or screws.
2. Insert 4 AA batteries into the battery pack, and place the battery
pack into the battery bracket.
3. Connect the data cables and secure them hand tight. When
completed, turn the hot & cold water lines counterclockwise to
turn the water back on.
*Recommended Placement
6.85 in
9.8 in
OR
Battery
Pack
POP-UP DRAIN INSTALLATION GUIDE
NOTE: The pop-up drain is fully assembled in the box. Disassemble
the pop-up drain so that each component is separate before installing.
After removing the existing drain from your sink, follow the
instructions below to install the pop-up drain.
1. Insert the drain tube through the sink.
2. Slide the washer and cone washer up the drain tube
from beneath the sink.
3. Secure the drain tube to the sink using the nut.
4. Press the drain into the drain tube.
5. Connect the drain tube to the bathroom plumbing. This process may
vary depending on the sink and plumbing of your home. Some methods
include threaded connections, while others use compression fittings.
Drain
Drain Tube
Washer
Cone Washer
Nut