10 11
GETTING STARTED
Warm Air Dryer
Press to activate the warm air dryer. Adjust the dryer temperature by
pressing “+” and “-” . (Temperature can be adjusted up to 5 levels.)
Adjustable Water Pressure
Press “+” or “-” during a wash cycle to adjust the water pressure
to your desired level.
Adjustable Water Temperature
Adjust the water temperature by pressing the corresponding
button to cycle through 5 temperature levels.
Adjustable Heated Seat
Adjust the heated seat by pressing the corresponding
button to cycle through 5 temperature levels.
Auto Oscillation
Press “Stop” and “^” during a wash cycle to turn automatic
oscillation on/off.
Adjustable Nozzle Position
Push the “^” or “v” during a wash cycle to adjust the nozzle position.
GETTING STARTED
Nozzle Cleaning
• This product has an automatic nozzle cleaning function that rinses
the nozzle before each use.
• Press “Nozzle Cleaning” to activate a nozzle cleaning cycle
that rinses the nozzle 10 times.
• Press and hold the “Rear Wash” button on the side control panel
for 5 seconds while not seated to extend the nozzle without
spraying for 2 minutes. Gently clean the nozzle with a soft cloth
or toothbrush. Press the “Stop” button to retract the nozzle.
Eco Mode
Press to turn energy saving functions on/off. When enabled,
eco mode will decrease temperature settings when not seated.
Night Light
Press the “Stop” and “Turbo Wash” buttons for 3 seconds to turn
the night light on/off.
Smart Seat Sensor
Press the “Stop” and “Nozzle Cleaning” buttons to turn
the seat sensor on/off.
Sounds On/Off
Beeping can be enabled or disabled by pressing and holding the
“Stop” and “+” buttons while not seated.
Vibration On/Off
Press the “Stop” and “v” buttons to turn the remote
vibration touch on/off.
To Next Page
Loading...