11
User Instructions Continued
Display (Shown on the appliance screen)
200797_1
Setting the day of the week and time
Press the DAY / TIME key. When the day is flashing press the ▲ or ▼ key to select the day.
Press the DAY / TIME key again, then press the + or – key to set the hour.
Press the DAY / TIME key again, then press the + or – key to set the minute.
Press the OK key to confirm the setting.
NOTE: This setting is only applicable for the temperature in standard heating mode, not for
the temperature in the timer mode. The default set temperature is 20℃.
NOTE: The heater will only start working when the set temperature is higher than the room
temperature.
Press the + or – key to set the temperature, which ranges from 15 to 30℃.
After the temperature setting has been completed, the display flashes for approximately
5 seconds, then shows the room temperature.
Timer
Standby mode
Day of the week
Heating level
Low heat
High heat
Automatic heating mode
Time / temperature display
Timer on
Timer off
Temperature / timer
Setting the temperature
Note:- The display will stay illuminated for approximately 8 – 10 seconds
To Next Page
Loading...
Need help?
General
