SpA RT 80
8
11 - END-OF-SEASON MAINTENANCE
OIL DRAG PLUG :
For whatever mechanical repair in the ear-box or in the mill-descent, it’s
necessary to remove the oil.
To make the transmission empty , unscrew the plug “V” placed in the lowest
section of the gear-box.
Before parking the machine:
• wash it accurately with gas oil,
• empty the carburetor tank and clean or replace air f ilter,
• lubricate and grease all articulated joints and gears,
• replace or repair possible worn parts,
• lubricate cylinder with motor oil through the spark plug hole, pull the start-up
cord so that the piston makes some strokes
• Park the machine in a dry place with wheels on wood tables or even better with wheels up f rom the floor.
12 - POSSIBLE PROBLEMS AND SOLUTIONS
Possible problems that can be solv ed by the machine operator:
MOTOR - The motor does not start; check that:
• the gasoline in the tank is more then half .
• the gasoline cock is open
• if the motor is cold , the starter lever is pulled
• the gasoline reaches the carburetor
• the bleed on the tank cap is not clogged
• carburetor jets are not clogged, if necessary , clean
them with air jet
• the spark plug sparks, in order to carry out this check
operation unscrew the spark plug; connect it to the power
supply cable, place the spark plug earthed metal part
(motor cy linder) and make the motor pulley turn as in the
start-up phase. If electrodes do not spark, check the
supply cable junctions, and if this does not solv e y our
problems, replace the spark plug with one of the same
ty pe. If even this time y ou should not obtain positive
results, the defect concerns the electric plant (points,
condenser, coil etc.)In this case it is advisable to contact
the nearest service (according to the motor assembled on
the machine).
13 - INSTRUCTIONS FOR A GOOD OPERATION OF THE MACHINE
• Carry out a good breaking-in of the motor and of the
machine (for at least 10 hours do not exceed 70%of motor
power)
• alway s use the clutch before using any lev er
• do not keep the clutch disengaged for long periods of
time
• never f orce gear lev ers, if y ou cannot engage them,
jerkily release the clutch
• never force the motor.
• do not work at full speed for long periods, in particular
during hot day s
• periodically check tyres pressure ( Atm. 1.3)
• when assembling the diff erent tools, do not damage
shaf t spigot and spline, check that tool screws and lockpin
are tight, in particular the rotary tiller hoe screws and the
screws f astening the mowing bar
• do not leav e the machine in the rain.
IMPORTANT: using the machine for a
long time you should use ear
protection system.
To Next Page
Loading...