SpA RT 80
7
WORKING WIDTH : 45 cm.
4 two-side joiners
2 spacers
1 pin cm.36
1 bonnet cm.45
WORKING WIDTH : 58 cm.
4 two-side joiners
2 one-side joiners
4 spacers
1 pin cm.55
1 bonnet cm.58
WORKING WIDTH : 65 cm.
6 two-side joiners
4 spacers
1 pin cm.55
1 bonnet cm.65
10 - MAINTENANCE AND LUBRICATION
PLUG-CONTROL :
From time to time it’s necessary to check the plug wear-level and the
electrodes-distance, which must be of 0.5 mm , as shown in the near drawing.
AIR FILTER CLEANING :
This operation must be perf ormed regularly in the following way:
• clean the filter externally, so to av oid that some earth f alls inside during the
disassembling.
• Loose the clips “P”, remov e the oil-cup “Q”, take away the f ilter-element “R”
and wash carefully the dif f erent parts with gasoline oil.
• Fill the cup with new oil till reaching the lev el, as pointed out in the picture.
OIL INLET BLEED :
Every component of the gear-box and transmission is in oil-bath. It’s
necessary to check from time to time the oil-lev el through screw “S” and fill it up
again, if required, through the vent plug “T”.
USE ONLY OIL FOR TRANSMISSION SAE 30
FRONT-WHEEL OIL LEVEL PLUG :
Check from time to time the oil level on the front wheel through plug “U”, placed
on one side, as shown in the picture. For a perfect machine ef f iciency, a good
maintenance and a perf ect lubrication are necessary .
Check that air f ilter is clean, in case of oil bath filter check lev el ev ery 8-10
operating hours or ev en more frequently when working in dusty grounds. Use motor
oil to restore oil lev el and clean the cup bef ore f illing it.
GEARBOX Check oil level ev ery 50 operating hours remov ing the cap on the
gearbox sump keeping the machine in horizontal position.
If necessary add SAE 30 oil. It is advisable to replace oil at least every 100
hours.
MILLS Bef ore starting to work check that all screws are tight, check especially
rotary tiller hoe fastening screws.
To Next Page
Loading...