SpA RT 80
6
If this should not occur, apply to a skilled workshop by our concessionary agents.
In the picture, turning lever “A” left the rotary tiller is activated, on the contrary turning it right it is stopped.
POWER TAKE-OFF :
The motor hoe is equipped with a lateral power take off , which may be
employ ed both with stopped and running machine.
The power take of f and its own couplings are unif ied with most of commercial
fittings.
POWER TAKE-OFF OUTLINE:
Splined 16 UNI 221X120 mm. Working
Turning direction: lef t.
Max. rev. 440 at 5,000 engine/RPM.
MILL BONNET :
The milling-depth may be adjusted as f ollows: f or working on the surf ace,
it’s recommended to keep the safety-mill-bonnet lowered.
For a deep working, to sink more in the ground.
For these operations it’s suf f icient to act on the pin f ixing the bonnet “L” and on
adjusting pin “M”.
DIRECTION - JOINTER :
For getting a more regular machine adv ancement it is suff icient to operate the
adjustable direction-jointer.
When working on soft ground, it is required to keep the spur up, to help the
machine advancement.
On solid ground it’s right to keep the jointer down, so that sinking in the earth it
prevents a too quick machine advancement.
For this adjustment, act on the pin “N” fixing the jointer.
The machine presented in this manual has been designed to be used only in
agriculture and especially f or ground milling.
Any different use is considered contrary to its proper use.
The builder does not assume responsibility f or damages or injuries due to improper
use of the machine.
According to the norms, even the respect of the operation, maintenance, and repairing conditions f ixed by the Firm
BENASSI SPA is part of a correct use
The machine can be operated, maintained and repaired only by those operators who have read this manual and are
informed of possible dangers.
Any arbitrary modification on the machine exempts the Firm BENASSI SPA from any responsibility in case of
damages.
9 – MILL ASSEMBLING
WORKING WIDTH : 18 cm.
2 one-side joiners
1 pin cm.17
1 bonnet cm.18
WORKING WIDTH : 26 cm.
2 two-side joiners
1 pin cm.17
1 bonnet cm.26
WORKING WIDTH : 32 cm.
2 two-side joiners
2 one-side joiners
2 spacers
1 pin cm.31
1 bonnet cm.33
WORKING WIDTH : 38 cm.
2 two-side joiners
2 one-side joiners
2 spacers
1 pin cm.36
1 bonnet cm.38
To Next Page
Loading...
