Benavent IBB360 - Failure Display and Inspection

50
The induction hob or
a cooking zone has
turned itself off
unexpectedly, a
tone sounds and an
error code is
displayed
(typically
alternating with one
or two digits in the
cooking timer
display).
Technical fault.
Please note down the error
letters and numbers, switch
the power to the induction hob
off at the wall, and contact a
qualified technician.
Failure Display and Inspection
If an abnormality comes up, the induction hob will enter the protective state
automatically and display corresponding protective codes:
Problem
Possible causes
What to do
E4/E5
Temperature sensor failure
Please contact the supplier.
E7/E8
Temperature sensor of the
IGBT failure.
Please contact the supplier.
E2/E3
Abnormal supply voltage
Please inspect whether
power
supply is normal.
Power on after the power
supply is normal.
E6/E9
Bad induction hob heat
radiation
Please restart after the
induction hob cools down.
The above are the judgment and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any dangers and
damages to the induction hob.