1277-027
50L STAINLESS STEEL WET/DRY VACUUM
WET PICK-UP
1.
Install a foam filter over the filter basket.
NOTE:
Wet pick-up accessories should be washed periodically, especially after picking
up wet, sticky kitchen accidents. This can be accomplished with a warm solution
of soap and water.
2.
Insert the exhaust water pipe into the down drain hole. Tighten the screw of exhaust
water pipe with screwdriver. Put the exhaust water pipe in the hook of the tank.
Makes sure it higher than the tank.
3.
This wet/dry vac is equipped with a float mechanism which will rise automatically
and the motor noise becomes higher in pitch due to increased motor speed.
The liquid capacity may vary with the rate of pickup.
IMPORTANT:
To reduce the risk of damage to the vacuum, do not run motor with float
in raised position.
NOTE:
If accidentally tipped over, the vacuum could lose its suction ability. If this occurs,
to its normal position, and you will be able to continue operation.
To Next Page
Loading...
Need help?
General
