12
1277-027
50L STAINLESS STEEL WET/DRY VACUUM
MAINTENANCE
WARNING
To reduce the risk of injury from accidental starting, unplug power cord before
changing or cleaning filter. The filter should be cleaned often to maintain peak
Vacuum performance. Do not remove filter cage and float. The float prevents
water from entering the impeller and damaging the motor. The cage prevents
fingers from touching the moving impeller.
NOTICE
To avoid damage to the impeller and motor, always reinstall the reusable filter
before using the vacuum for dry pickups and always reinstall the foam filter
before using the vacuum for wet pickups.
After cleaning, check the filter for tears or small holes. Do not use a filter with holes
or tears in it. Even a small hole can cause dust to come out of the vacuum. Replace
it immediately.
Before installing the filter on the vacuum, clean the area of the lid so that the clamp
ring will seal the bag against the lid and stop small particles from bypassing the filter
bag. If the filter is clean and not damaged, replace it on the filter cage. If it cannot
be reused, place a new filter over the filter cage.
Clean the filter in an open area.
CLEANING
To keep the wet/dry vacuum looking its best, clean the outside with a cloth
dampened with warm water and mild soap.
To clean the tank:
1. Dump out debris.
2. Wash tank thoroughly with warm water and mild soap.
3. Wipe out with dry cloth.
STORAGE
Before storing the vacuum, the dust tank should be emptied and cleaned.
The cord should be wrapped and hung on the unit and the accessories should
be kept in the accessory holder so they can be readily available. The vacuum
should be stored indoors.
To Next Page
Loading...
