11
EMPTYING THE TANK
WARNING
To reduce the risk of injury from accidental starting, unplug power cord before
emptying the dust tank.
FOR DRY USE
1. Remove the power head assembly of the wet/dry vacuum by pulling
power head assembly.
2. Dump the tank contents into the proper waste disposal container.
FOR WET USE
Take down the exhaust water pipe from the hook, the liquid of the tank
will drain from it.
BLOWING OPERATION
WARNING
Always wear safety eyewear complying with ANSI Z87.1 (or in Canada CSA Z94.3)
when using as a blower. To avoid injury to bystanders, keep them clear
of blowing debris.
CAUTION
Wear a dust mask if blowing creates dust which might be inhaled. To reduce
the risk of hearing damage, wear ear protectors when using the vac/blower
for extended hours or or in confined space.
The vacuum contains a blowing feature. Follow the steps below to use
the vacuum as a blower.
1. Locate blowing port on the vacuum.
2. Insert one end of the 6 ft x 1-7/8 in / 1.8 m x 48 mm hose into
the blower port.
3. Turn the vacuum “ON”.
To Next Page
Loading...
