8
1277-027
50L STAINLESS STEEL WET/DRY VACUUM
Know Your Wet/Dry Vacuum – Cont’d
ATTENTION
Read the entire important safety information section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
UNPACKING & SET-UP SUMMARY
1. Pull lid latches in an outward motion, remove power head and some
accessories that may have been shipped in the tank.
2. Attach caster following the instructions as below:
a. Invert dust tank, insert two casters into hole of base.
b. Put the caster pole on the right position of the base. Align two holes of
the pole with two holes of the base. Secure with screws provided.
c.
3.
Return dust tank assembly upright.
4. Before replacing power head, refer to this manual to ensure you have
the proper filters installed for the cleaning operation.
5. Replace power head, and apply pressure with thumb to each latch until
it snaps tightly in place. Make sure all lid latches are clamped securely.
6. Insert the hose end into inlet of tank.
7. Attach the extension wands to the end of the hose. Apply slight pressure
until fitting is tight.
8.
Attach one of the cleaning accessories (depending on the cleaning requirements)
on the extension wands. Twist slightly to tighten the connection.
9. Plug the cord into the wall outlet. The cleaner is ready for use.
10. Turn the unit “ON” by pushing the switch from position “O” to position “I”.
The
Attach the drain hose to the drain on the canister.
NOTE: THE DRAIN HOSE MUST BE INSTALLED ON THE DRAIN IN ORDER
FOR THE VACUUM TO OPERATE PROPERLY.
“O” is the “OFF” position and the “I” is the “ON” position.
WARNING
To reduce the risk of fire or explosion, do not operate this vacuum in areas with
flammable gases, vapors or explosive dust in the air. Flammable gases or vapors
include but are not limited to: lighter fluid, solvent-type cleaners, oil-based paints,
gasoline, alcohol or aerosol sprays. Explosive dusts include but are not limited to:
coal, magnesium, aluminum, and grain or gun powder. Do not vacuum explosive
dust, flammable or combustible liquids or hot ashes. Do not use this vacuum as
a sprayer for any flammable or combustible liquid. To reduce the risk of health
hazards from vapors or dusts, do not vacuum toxic materials.
WARNING
The operation of any utility vacuum can result in foreign objects being blown
into the eyes, which can result in severe eye damage. Always wear safety eyewear
complying with ANSI Z87.1 (or in Canada, CSA Z94.3) before starting operation.
CAUTION
To reduce risk of hearing damage, wear ear protectors when using the vacuum
for extended hours or when using it in a noisy area.
To Next Page
Loading...
Need help?
General
