9
• Do not use the saw until the table is clear of all tools, wood scraps, etc., except
for the workpiece. Small debris or loose pieces of wood or other objects that
• Cut only one workpiece at a time. Stacked multiple workpieces cannot be
• Ensure the miter saw is mounted or placed on a level, firm work surface
before use. A level and firm work surface reduces the risk of the miter saw
• Plan your work. Every time you change the bevel or miter angle setting, make
sure the fence will not interfere with the blade or the guarding system. Without
turning the tool “ON” and with no workpiece on the table, move the saw blade
through a complete simulated cut to assure there will be no interference or
• Provide adequate support such as table extensions, sawhorses, etc. for a
workpiece that is wider or longer than the tabletop. Workpieces longer or wider
• Do not use another person as a substitute for a table extension or as additional
support. Unstable support for the workpiece can cause the blade to bind or the
workpiece to shift during the cutting operation pulling you and the helper into
•
• Always use a clamp or a fixture designed to properly support round material
such as rods or tubing. Rods have a tendency to roll while being cut, causing the
• Let the blade reach full speed before contacting the workpiece. This will reduce
•
moving parts to stop and disconnect the plug from the power source and/or
remove the battery pack. Then work to free the jammed material. Continued
sawing with a jammed workpiece could cause loss of control or damage to the
• After finishing the cut, release the switch, hold the saw head down and wait for
• Hold the handle firmly when making an incomplete cut or when releasing the
switch before the saw head is completely in the down position. The braking
action of the saw may cause the saw head to be suddenly pulled downward,
To Next Page
Loading...
