1347-001
20V MAX 7-1/4” SLIDING COMPOUND MITRE SAW
12
WARNING: Use of this tool can generate and/or disperse dust, which may
cause serious and permanent respiratory or other injury. Always use NIOSH/
OSHA approved respiratory protection appropriate for the dust exposure. Direct
protection that conforms to ANSI S12.6 (S3.19) during use. Under some conditions
CAUTION: When not in use, place tool on its side on a stable surface where it will
not cause a tripping or falling hazard. Some tools with large battery packs will stand
• When replacing the blade, make sure the replacement blade is 7 1/4" in
diameter and is rated for at least 3600 RPM. Installing an incorrect blade will
result in possible injury and poor cutting action.
• After changing a blade or making adjustments make sure the blade clamp
screw is securely tightened. Loose blades and adjustment devices will be
violently thrown.
• Never touch the blade during or immediately after use. After use, the blade is too
hot to be safely touched with bare hands.
To Next Page
Loading...
