5
9. Stop the cutting blade(s) if the product has to be tilted for transportation when
crossing surfaces other than grass, and when transporting the product to and
from the area to be mowed.
10. Never operate the product with defective guards, or without safety devices,
11. Start the product or switch on the product carefully according to instructions
and with feet well away from the cutting blade(s).
for example deflectors and/or grass catchers, in place.
12. Do not tilt the product when switching on the motor, except if the product
has to be tilted for starting. In this case, do not tilt it more than absolutely
necessary and lift only the part, which is away from the operator.
13. Do not put hands or feet near or under rotating parts.
Keep clear of the discharge opening at all times.
14. Never pick up or carry a product while the safety key is inserted.
15. Stop the lawn mower and remove the safety key and batteries. Make sure that
all moving parts have come to a complete stop:
• whenever you leave the product
• before clearing out grass
• before checking, cleaning or working on the product
• after striking a foreign object, inspect the machine for damage and make repairs
before restarting and operating the product
16. If the product starts to vibrate abnormally (check immediately)
• inspect for damage
• replace or repair any damaged parts
• check for and tighten any loose parts
MAINTENANCE AND STORAGE
1. Keep all nuts, bolts and screws tight to be sure the product is in safe working
condition.
2. Check the grass bag frequently for wear or deterioration.
3. Be careful during adjustment of the product to prevent entrapment of the fingers
between moving blades and fixed parts of the product.
4. Allow the product to cool before storing in any enclosure.
5. When servicing the blades be aware that, even though the power source is switched
6. Replace worn or damaged parts for safety. Use only genuine replacement parts and
accessories.
7. Wear strong work gloves when removing and re-assembling the cutting blade.
To Next Page
Loading...
