17
WARNING
Wear safety gloves when handling cutting devices in order to avoid injuries like burns
and cuts.
WARNING
Make sure all bolts are completely tightened before operating the machine. Don't
operate the machine if any bolts are missing, loose, or damaged.
The product is designed for raking and the raking cylinder is preassembled on the
machine. The cylinder can be changed according to the application.
Replace the raking cylinder
1. Loosen the inner hexagon on the bearing seat and unscrew it counterclockwise.
2. Then take out the raking cylinder.
3. Align the rectangular hole at one end of the comb blade with the square output
shaft on the base.
4. Press the bearing on the grooming blade into the bearing seat, and then tighten
the hexagon socket screw clockwise.
To Next Page
Loading...