16
5150-004
13 AMP ELECTRIC DETHATCHER
MAINTENANCE
WARNING
Before carrying out any repairs or servicing work, you must ensure that the machine
has been disconnected from the power supply. Repairs and maintenance work other
than described within this instruction manual may be performed only by qualified
specialist!
Service + Storage
To ensure long and reliable service, carry out the following maintenance
regularly. Servicing and cleaning work on the machine and the removal of the
guards may only be carried out after the motor has been switched o and the plug
disconnected from the power supply.
∫ Keep all nuts, bolts and screws tight to be sure the product is in a safe working
condition.
∫ Allow the product to cool before storing in any enclosure.
∫ Check the thatch collection bag frequently for wear or deterioration.
∫ Examine the product regularly and replace worn or damaged parts for safety.
∫ Check that covers and guards are undamaged and correctly fitted. Carry out
necessary maintenance or repairs before using the machine.
∫ If the cutting device should happen to fail despite the care taken in manufacturing
and testing, repair should be carried out by an authorized repair facility.
∫ Do not clean the machine while it is running.
∫ Ensure that all the fastening elements (screws, nuts, etc.) are tight at all times so
that you can safely work with the machine.
∫ Check the machine frequently for signs of wear. Replace worn or damaged parts.
∫ Store your machine in a dry place. To ensure a long service life all screws and
bolts should be cleaned and then oiled.
∫ Clean the machine with a brush or cloth. Do not use any solvents or water to
remove dirt.
∫ The component that is subject to most wear is the cutting device. You should
therefore check the condition of the cutting device and its mounting at regular
intervals.
∫ If the cutting device is worn or blunt it must be replaced immediately.
∫ If the machine starts to suer from excessive vibrations, this means that the
cutting device has not been balanced correctly or has suered deformation due
to impacts. In this case it must be repaired or replaced.
Replacing/Changing Cutting Device
WARNING
Always switch the machine o, disconnect it from power supply and let it cool down
before changing / replacing the cutting device.
WARNING
Cutting devices are very sharp and become hot during use. Handle them carefully.
To Next Page
Loading...