16
INSTALLING FRONT GUARD
Install guard using four M8 x 20 mm hex head bolts, split lock washers, flat washers
and nuts.
Engine Preparation
NOTICE
Engine shipped without oil. Failure to add oil will result in serious engine damage.
A bottle of engine oil is included with your tiller. Refer to the chart on the right for
alternative oil types to use at dierent temperatures. Always use a high quality
detergent oil classified “For Service, SG, SH, SJ” or higher. Do NOT use special
additives.
A
SAE 30 - Below 40 °F (4 °C) the use of SAE 30 will result in hard starting.
B 10W-30 - Above 80 °F (27 °C) the use of 10W-30 may cause increased oil
consumption. Check oil level more frequently.
C
5W-30
D
Synthetic 5W-30
E
Synthetic 15W-50
To Next Page
