23
5140-011
212CC/4-CYCLE GAS REAR TINE TILLER
HANDLEBAR ADJUSTMENT
The ideal height of the handlebar varies with operator height and the depth of tilling.
To adjust handlebar height:
1. Unscrew and remove the top bolts and nuts on the lower handle on each side.
2. Loosen the lower bolts. Do not remove.
3. Align handlebar to desired holes on the lower handlebar mount.
4. Install bolts and nuts. Retighten all four bolts securely.
DEPTH REGULATOR
Tilling depth is controlled by the height of the depth regulator. To adjust tilling
depth:
1. Remove pin.
2. Raise the depth regulator to position tines at chosen tilling depth.
3. Align hole in depth regulator with hole in depth regulator bracket and replace
pin.
Depth Regulator Down = Shallower tilling.
Place the pin in the top hole of the depth regulator for shallowest tilling.
Depth Regulator Up = Deeper tilling.
Place the pin in the bottom hole of the depth regulator for deepest tilling.
WARNING
Do not adjust tilling depth unless clutch control levers are released to neutral
position. Always set the depth regulator in the transport position before starting
engine, that is, place the detent pin in the highest hole of the depth regulator.
Transport position
Shallowest tilling position
Deepest tilling position
To Next Page
