40
END OF WORK
1. Bring the machine to a complete stop.
2. Move the Throttle Lever (9) to SLOW and turn off the engine by turning the Key
Ignition Switch (13) to OFF.
3. Engage Park Brake Lever (14).
4. When the engine has stopped, rotate the Fuel Shut Off Valve on the Fuel Cap (6) to
closed OFF.
5. Remove the Ignition Key (13)
To avoid backre, position the Throttle Lever (9) to SLOW for 20
seconds before stopping the engine.
Always remove the Ignition Key (13) before leaving the machine
unattended! To keep the battery charged, do not leave the Ignition Key (13) in the ON
position when the engine is not running.
CLEANING THE MACHINE
1. After use, clean the outside of the machine, empty the discharge chute, and
shake it to remove grass and other debris.
2. Clean the plastic parts of the body with a damp sponge using water and
detergent, taking care not to wet the engine, the electrical parts or the electronic
circuit board located under the dashboard.
Never use hose nozzles or harsh detergents to clean the
bodywork or the engine!
When washing the inside of the cutting deck, the machine must be on firm ground
with:
▪ The discharge chute fitted.
▪ The operator seated.
▪ The engine running.
▪ The transmission in neutral N.
▪ The blades engaged.
1. Connect a water hose to each of the
pipe fittings one at a time and run
water through each one for a few
minutes, with the blades moving.
2. When washing, the cutting deck
should be in the lowest position.
To Next Page
Loading...
