48
All checks, adjustments and replacements not described in this manual
must be carried out by your Dealer or an authorized Service Center. Both have the
necessary knowledge and tools to ensure that the work is carried out correctly
without affecting the safety of the machine.
ENGINE
Follow all the instructions in the engine manual.
To empty the engine oil, unscrew the oil plug when refitting the plug, make sure the
seal is positioned correctly.
BATTERY
The battery must be carefully maintained to ensure long life.
The machine battery must always be charged:
▪ Before using the machine for the first time after purchase.
▪ Before leaving the machine unused for a long period.
▪ Before starting up the machine after a long period of unuse.
1. Carefully read and observe the battery recharging instructions in the booklet
provided with the battery. Failure to follow the instructions or in charging the
battery could permanently damage the battery cells.
2. A flat battery must be recharged as soon as possible.
Recharging must be done using a battery charger at constant voltage.
Other recharging systems can irreversibly damage the battery.
CUTTTING DECK CHECKS AND ADJUSTMENTS
The cutting deck should be properly set to obtain a good cut.
For achieving good results from cutting, the front part should always be 5-6mm
lower than the rear.
1. Put the machine onto a flat surface and check the tire pressures.
2. Put 30 mm blocks under the front edge of the deck and 35 mm blocks under the
rear edge, and then put the Cutting Height Adjustment Lever (2) into position 2.
3. Adjust the left front adjuster rod, right front adjuster rod and right rear adjuster
rod keep the deck in touch with the blocks.
4. Adjust the lift rod to keep the deck in touch with the blocks.
To Next Page
Loading...
