Benchmark BW Series - Changing the Engine Oil

32
TM
7.2 CHANGING THE ENGINE OIL
WARNING!
Used motor oil can cause skin irritations if left in long-term
contact with skin. Thoroughly wash off used oil as soon as
possible with soap and water.
Do not dispose of used oil in drains or on soil. Local service
shops provide environmentally-friendly disposal methods.
Drain the oil rapidly and completely on a level surface while the engine is still warm.
1. Stop the engine and remove oil ller dipstick.
2. Place a pan under the engine to catch the oil.
3. Remove the oil drain bolt and allow the oil to completely drain into the pan
by tilting the pressure washer back and to the side to empty the oil from the
crankcase.
4. Return the pressure washer to a level position and reinstall drain bolt. Fill
the engine with fresh oil (SAE 10W-30 4 Cycle Engine Oil) up to the
maximum mark on the dipstick without threading it back in. Do not overll
oil reservoir. Use a funnel to prevent spillage.
5. Reinstall the oil ller dipstick and tighten.
Oil Drain Bolt
Oil Drain Pan
<<31>>