Benchmark Media Systems, Inc.
Page 13 of 39
REMOVING TOP COVER:
The DAC1 has a removable cover. This cover provides access to the jumper settings on the PCB. The DAC1
contains static sensitive components and should only be opened by qualified technicians. Static discharge may
cause component failures, may affect the long-term reliability, or may degrade the audio performance. Use a
static control wrist strap when changing jumper settings.
Caution:
•
Disconnect AC power by unplugging the power cord at the back of the DAC1.
•
Remove only the 8 screws holding the cover (4 on each side).
•
Do not remove any screws on front or rear panels.
•
Never remove the power entry safety cover in the rear corner of the DAC1.
•
Use a static control wrist strap when changing jumper settings.
To Next Page
Loading...
Need help?
General