p.23
Voltage Settings
For voltage other than 115v.
Step 1: With the electronics guard plate
removed, use a phillips head
screwdriver to remove the four screws
securing the electronics core.
Step 2: Lifting up from the bottom and
making sure not to free any wires from
their positions, tilt the bottom of the
electronics core toward you to reveal the
red switch on the underside.
Step 3: Flip the red switch so that it reads
230v.
Step 4: Return the electronics core to its original position
and secure the panel with the four screws using the phillips
head screwdriver. Then, make sure to secure the
electronics guard plate with the four 3/8 nuts.
To Previous Page
Loading...
