p.22
Thank you for following this assembly guide.
The next step is to set up your Bend-Tech Dragon
software and follow through our Calibration wizard.
Support Concerns or Questions:
Michael
Support Team
2020 Software Solutions, Inc.
Contact Info
Phone: 651-257-8715
Email: michael@bend-tech.com; support@bend-
tech.com
Website: www.Bend-Tech.com
Address: 33510 Lincoln Rd, Lindstrom, MN 55045
****************************************************************************
The information transmitted is intended solely for the individual or entity to which it is
addressed and may contain confidential and/or privileged material. Any review,
retransmission, dissemination or other use of or taking action in reliance upon this
information by persons or entities other than the intended recipient is prohibited. If you
have received this email in error please contact the sender by reply e-mail and destroy all
copies of the original message.
****************************************************************************
To Next Page
Loading...
