p.7
Assembling the New Rail
Step 1: With the help of a
friend, and some sturdy
supports to prop up the new rail,
line the tail end of the supported
rail up to the end leg from the
previous step and affix the rail,
support leg and pulley system
together with the 3/4 inch nut
and bolt for the pulley center,
9/16 inch bolts, washers and coupler nuts
provided.
Be sure to remember the 3/4 inch bolt
and corresponding nut from Step 1 of
Dismantling the Support Leg that will
be secured to the bottom.
NOTE: The supports used to prop up the
bulk of the new rail (Not Included)
should raise the bottom edge up roughly
29 - 29 1/4 inches off the ground to match
the height of the stock rail.
To Next Page
Loading...
