p.8
Step 2: Line up the bare end of the new
rail with the 3 foot stock rail in
preparation to transfer the chuck to the
new rail.
Transferring the Chuck
Step 1: Use the chuck key
located in the slot on the top of
the chuck to loosen the chuck
from the gate. Turn the key
clockwise to draw the teeth of
the chuck inward and release it from the gate.
TIP: Using the 5/16 inch hex
wrench and loosening the
bottom 2 bolts on the front plate
directly below the chuck may
make the chuck transfer process
much easier.
Step 2: As a recommendation, we urge
you to degrease the rail and wipe it down
with a rag to remove any unnecessary
shipping grease before sliding the chuck
on. This will make the transfer process
easier and keep your machine running as smooth as
possible.
To Next Page
Loading...
