13 BW8207 Bendix Global Scalable Brake Control (GSBC) System Operator’s Manual
BENDIX GSBC DISPLAY & BEHAVIOR AT STARTUP CONT.
NOTE: Refer to the GSBC Dash Display Indicator Lamps and Operation section starting
on page 14 for more information about each lamp.
AUTOMATIC TRACTION CONTROL ATC STATUS/INDICATOR LAMP
If the vehicle is equipped with the Automatic Traction Control (ATC) feature, an
indicator lamp may be located in the vehicle display. At each ignition, the ATC
Indicator Lamp will illuminate for approximately three (3) seconds and then turn
o. If the ATC indicator lamp does not illuminate at ignition – or if it remains on
(not ashing) after ignition, or if it illuminates steadily (not ashing) while you are
driving – the ATC system may not be fully functional or may be completely disabled.
Have the vehicle serviced immediately by a qualied technician to restore full ATC
system functionality.
BENDIX® ELECTRONIC STABILITY PROGRAM® ESP INDICATOR LAMP
A yellow Electronic Stability Program (ESP) indicator lamp is located in the dashboard.
At each vehicle ignition, the ESP indicator lamp should illuminate for approximately
three (3) seconds and then turn o. If the lamp does not illuminate at ignition, or if
the indicator lamp remains on for more than three (3) seconds after ignition, or if it
illuminates while you are driving, the ESP system may not be fully functional or may
be completely disabled. If the ESP is completely disabled or not functioning properly,
have the vehicle serviced immediately by a qualied technician to restore full ESP
functionality. During an ESP intervention, the lamp will ash rapidly.
To Next Page