27 BW8207 Bendix Global Scalable Brake Control (GSBC) System Operator’s Manual
BENDIX GSBC SYSTEM TROUBLESHOOTING
Sensor Location Modications: The location and orientation of the Steering
Angle Sensor and Central ECU must not be altered. When servicing, an identical
component must be used and in the same orientation (using OEM brackets & torque
requirements). During installation follow the OEM leveling guidelines.
Steering Angle Sensor Recalibration: Whenever maintenance or repair work is
performed – on the steering mechanism, linkage, steering gear, adjustment of the
wheel track, if the steering angle sensor is replaced, or if any other alignment service
is performed – a recalibration of the steering angle sensor must be performed.
If the steering angle sensor is not recalibrated, the yaw control system will
not function properly, which could result in loss of control of your vehicle,
resulting in a potential collision, property damage, serious injuries, or death.
When replacing a steering wheel, use only a vehicle manufacturer approved
steering wheel and be sure that the steering angle sensor is not damaged
during installation. Recalibrate the steering angle sensor.
If replacement tires are used that are a different diameter from the
OEM-specied tire size, the brake control system must be updated with the
new tire size using the appropriate diagnostic tool. Contact your OE for more
information.
The location and orientation of the central Electronic Control Unit (ECU)
must not be altered. When servicing, an identical component must be used
in the same orientation using OEM mounting location, brackets, and torque
requirements.
To Next Page