8
BENDIX KING DPHX PROGRAMMING AND CLONING INSTRUCTIONS
**The instructions below are for analog narrowband frequencies. If you need to program digital frequencies,
see
the Digital Programming section below.**
1. Using a programming plug, hold red plug button then Function [FCN] key until display shows -- -- --
2. Enter Password (usually 000000), then press the Enter [ENT] key
3. Display will read Select a channel by entering the channel you want (1-16) then press the
[FCN]key
4 , press [CLR], then enter desired frequency (the
decimal will insert automatically). THEN PRESS [ENT].
5. Display will show -- .* DO NOT CHANGE. Press [FCN]
6. Display will show RX CG, the Code Guard or Tone. To change, press [CLR], enter in desired 4 digits (the
decimal will insert automatically), THEN PRESS [ENT]. To skip press [FCN].
7. Display will show .* DO NOT CHANGE-Press [FCN] to skip.
8. Display will show .* DO NOT CHANGE- Press [FCN] to skip.
9. press [CLR], then enter desired frequency (the
decimal will insert automatically) THEN PRESS [ENT].
10. Display will show -- DO NOT CHANGE. Press [FCN] to skip.
11. Display will show TX CG, the Code Guard or Tone. To change, press [CLR], enter in desired 4 digits (the
decimal will insert automatically)THEN PRESS [ENT]. To skip press[FCN].
12. Display will show * DO NOT CHANGE. Press [FCN] to skip.
13. Display will show .* DO NOT CHANGE. Press [FCN] to skip.
14. Display will show channel label. See page 9 below for label editing instructions. To skip press [FCN]
15. Display will read Select next channel (press [PRI] for next channel) to program and repeat steps
1-14.
*=DIGITAL FUNCTIONS
CLONING
1. Obtain programmed Master radio.
2. Turn on Master and Slave (your) radios and attach cloning cable between radios. Make sure all scan and
priority switches are OFF for both radios.
3. Select desired group to program in Slave radio
4. Access Programming mode of MASTER radio. (see above)
5. With Master radio display reading press the * key on the Master radio
6. will appear in screen and flash.
7. Press the Function [FCN] key and will appear without flashing as the slave radio is programmed
flash VH-1)
8. Turn off slave, and connect and program the next slave by pressing the [FCN] key once again.
- an error has occurred. Seek Help.
NOTES:
1. In step 4 above, after you enter in a channel number, 15 for example, you may see 15N. The N means the
frequency is Narrowband.
2. Press the # key. You should see the N disappear, and now the channel is Wideband
If you have trouble keying in a tone or changing groups, your keypad may be locked. Look at your screen, and if it says
than press and hold the [FCN] UNLOCKED.
Use caution when field programming any radio. These instructions are designed for radio users with field
programming experience. If you are unfamiliar with these procedures, seek out someone who is.
To Next Page
General