RJW Series of Rolling Jacks 21 P/N 5900093 — Rev. B — October 2020
3. Press and hold the RELEASE end to lower the Rolling Jack down onto the nearest Safety Lock.
4. Release the RELEASE end of the pump when the Jack engages on the Safety Lock.
This drawing shows the Jack engaged on a Safety Lock; the Safety Lock is held in place on the
Safety Lock Pin by the weight of the Vehicle on the Rolling Jack.
⚠ WARNING Only leave your Rolling Jack on a Safety Lock or fully lowered.
5. To lower the Rolling Jack: press the PUMP end of the pedal to get it off the Safety Lock Pin, pull
up on the Safety Handle to move the Safety Lock Pins out of the way, then press and hold the
RELEASE end of the Pump.
The Rolling Jack begins lowering.
6. When the Jack is fully lowered, release the RELEASE end of the pedal.
Assuming the test went fine, your Rolling Jack is ready for normal operation.
If there were issues, resolve the issues before beginning normal operation. Refer to
Troubleshooting for additional information.
To Next Page
Loading...
Need help?
General
